TangoDown magazine catch for Gen4 Glocks. Inset: factory Glock mag catch for comparison.

Glocks are pretty much ready to go right out of the box, especially if you opted for a set of steel sights. However, that doesn’t mean you can’t improve on “Perfection.” After a set of 10-8 sights, one of my favorite modifications has been the Vickers Tactical magazine catch produced by TangoDown. They are available for the small and large frame guns, and are available for all generations of Glock pistols.

Looking at the Gen4 factory magazine catch, there is a pronounced sweet spot near the front of the magazine catch button, much like the Gen3 factory catches. The Gen4 magazine catch is wider, and not too hard to release, but there is room for some improvement. The Vickers/TangoDown catch widens the sweet spot and the serrations are placed near the rear of the catch to reduce the reach distance for the shooter’s thumb. The catch itself is made of the same robust material as the factory catch; no cheap, soft plastic here. A flat blade screwdriver and five minutes is all you’ll need to remove the old catch and install the new one.

Will this one accessory turn you into a ghetto gunfighter? No. But it may add a few percentage points to the consistency of your reloads (as it did mine), and in this game, I’ll take every point I can get.

SOURCE: TangoDown

PS. The catch is now available in the Glock factory black or tan/FDE color.